Serial 1 eBike Touch Up Kit

TouchUpDirect Combo Applicator

On one side is the Pen applicator. The pen has a firm, chiseled nib applicator designed to work against shallow rock chips and scratches. On the other side is the Brush applicator. The Brush is a versatile tool that can handle both slightly larger touch up needs and smaller sized damage. The Combo Essential Kit is best for superficial, light scratches.

TouchUpDirect eBike Touch Up Kit

• This kit is designed for those small chips, nicks and scratch on your Serial 1 eBike doors, bumper, and everywhere in between.
• Two in one, brush-in-cap and pen-style applicator.
• The firm chiseled nib tip enables you to apply a very small amount and stay within the confines of the damaged area.
• Filled with 0.35 oz. of our low-VOC environmentally friendly touch up paint. Enough paint to cover at least 10 square inches. This means you will have enough paint for multiple touch up projects.
• This kit includes: one pack of Wax and grease remover wipes to clean the surface before painting. One Colorcoat touch up combo applicator that matches the color of your Serial 1 eBike. One Clearcoat touch up combo applicator for the final finish and protection.
• Kit also includes instructions on how to touch up your vehicle and a test card to make sure the color matches before you paint it on your eBike.

How To Use

• Step 1: Clean and prep surface, lightly wipe down the area with long & even strokes. Avoid circular motions.
• Step 2: Apply Colorcoat - For small nicks and dings use the Pen. For scratches, use the Brush. If you’re using the Pen side, unscrew the cap and dab the surface until the repair area is lightly and evenly covered. If you’re using the Brush side, apply paint evenly over the damaged area until fully covered. For both the Pen & Brush, you should apply 2-3 coats. Allow 15 minutes to dry in between coats. 
• Step 3: Apply Clearcoat - If you’re using the Pen side, unscrew the cap and dab the surface until the repair area is lightly and evenly covered. If you’re using the Brush side, apply Clearcoat evenly over the damaged area until fully covered. For both the Pen & Brush, you should apply 2-3 coats. Allow 15 minutes to dry in between coats.